SC-CPI Interface bus CPI para datalogger
Data Logger to CDM Bridge
Synchronized high-speed measurements
meteorología aplicaciones agua aplicaciones energía aplicaciones flujo gas y turbulencia aplicaciones infraestructuras aplicaciones suelo aplicaciones

Resumen

El SC-CPI es un interface puente entre el puerto serie de los dataloggers CR800/850, CR1000, CR3000 y nuestros nuevos módulos CDM (Campbell Distributed Modules). Los módulos CDM utilizan el nuevo CAN peripheral interface (CPI), y el módulo SC-CPI permite a los dataloggers mencionados anteriormente, conectarse al puerto CPI de los módulos CDM. Los nuevos dataloggers dispondrán por defecto de la toma CPI.

Ventajas y características

  • Enables a CR800, CR850 CR1000, or CR3000 to be part of a CPI/CDM network
  • Provides detailed CPI communication diagnostics
  • Supports monitoring of the serial or CPI load
  • Indicates if CPI frame errors occur
  • Provides information about each CPI module that it detects in its network

Imágenes

SC-CPI shown with connector and 29526 cable attached (a Ships With item)
SC-CPI shown with connector and 29526 cable attached (a Ships With item)
SC-CPI shown with connector and 29526 cable attached (a Ships With item)

Preguntas frecuentes

Número de FAQs relacionadas con SC-CPI: 2

  1. What hardware is needed to make a CDM-VW300 or a CDM-VW305 work?

    To communicate with CDM devices using the CPI protocol, the CR3000, CR1000, CR850, and CR800 dataloggers require an SC-CPI device. Only one SC-CPI device per data logger is required. It is expected that the design of future Campbell Scientific data logger products will work with CPI-based modules directly.

  2. What is the CPI bus?
    The communications protocol used by CDM devices is the CAN Peripheral Interface (CPI), which includes methods that are proprietary to Campbell Scientific.
Visite la librería de FAQ

Especificaciones

Temperature Range
  • -25° to +50°C (standard)
  • -55° to +85°C (extended)
Current Drain 50 mA (active)
Dimensions 15.94 x 7.49 x 3.18 cm (6.28 x 2.95 x 1.25 in.) including ground lug
Weight 0.188 kg (0.415 lb)

Connectors
CPI RJ45
Serial Connect to Data Logger Screw terminal
Computer Configuration via Device Configuration Utility USB

Compatibilidad

Nota: lo siguiente muestra información de compatibilidad notable. No es una lista de todos los productos compatibles.

Dataloggers

Producto Compatible Nota
CR1000 (retired)
CR200X (retired)
CR216X (retired)
CR3000 (retired)
CR800 (retired)
CR850 (retired)
CR9000X (retired)

Información de compatibilidad adicional

Data Logger Considerations

A 5-conductor cable connects the data logger to the SC-CPI, and an Ethernet cable connects the SC-CPI to the CDM.

The data logger operating system must be version OS 26.