dear all
i have recently modify a program for my cr3000 and i send this new program by gprs.
but at this time i still have not receive anything of my station. it's the seventh day.
i have no connection.
my gprs are on the SW12 and anything was modify in this section.
do you have an idea? does it's possible the cr3000 are crashed?
i think the changes are not taken into account if the program has not been completely sent
but it's sure?
while waiting to read you
sincerly
Francois
Did you have a command in the program to turn the SW12 on?
Copy your program here or email it to me and I will see if I can find the problem
Cheers
Grant
dear grant dear all
i have find a mistake in my program
so
when the cr3000 compil, he send an error
and the sw12 is not powered
i can't connect
i think there is no solution except an intervention on the site?
thank you
Francois
That sounds like the only way to fix the problem.
The good news is that you will learn from this and not have the same problem again.
Cheers
Grant
A lesser known trick to avoid this in future is to put a small program on the logger called default.crx (where x is replaced by the relevant digit for the logger). This program will run if you load a program that does not compile or you inadvertently stop the main program running some other way. You can put whatever you like in that default program, but in your case a few lines just to turn on the SW12V all the time would avoid this issue.
dear all
thanks for your answer
as you write it's i will learn from my mistake.
the small program called default.cr3 works perfectly.
i'm happy to know this.
in the future i would not be without resources
thanks