Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.
Question/Topic Posted By Replies
Rename data file in card memomy Jamal 1
MD485 Communication Thein 11
Load cell CR1000 program help please? BronwynH 1
HC2-S3 problem; too high temperature Tomek 1
hex communication string BartZaw 2
RM Young 81000 v/s serial port CR1000 jelguetacenma 6
CR1000 connection with Loggernet 4.0 through RS232 dsclimate 5
controlling switched voltage power, weak signal to modem ekahler 2
switching modem to PPP ekahler 0
Possible to connect non-Campbell device to CR1000? StevemT 1
U,V,W, SonicT measurement from voltage o/p of RM 81000 in differential mode dsclimate 0
radio configuration to collect from remote site ekahler 3
CR6 with CDM-VW305 Geoprojektas 2
OBS 3A turbdiity coefficients snovoa77 0
relaying data from buoy via land-based GOES jankplus 0
CR800 modbus master with NL201 acloward 0
string of data parameters through tcp ip maurixio 1
Lufft WS200-UMB on CR1000 Charlotte 1
insolation time maurixio 3
CR1000 stop logging with GETVARIABLES instruction LeonardoOliveira 1
Help with skipped slow sequence scans ganzlin 5
Get Variables Command AJG 5
Using the Fieldnames() instruction jra 0
setup and connection error with loggernet ekahler 4
csat3 anolog wiring CarloDguezUV 3
Soiling system Airtec 0
Task just works the first time. KezinDazel 1
IPROUTE() Instruction jtelocken 2
Using Delphi with Pakbus mewindy2 2
Starting a CR3000 program with software or hardware switch Phenomics 2