FAQs Preguntas frecuentes acerca de nuestros productos y soluciones

Realizar consulta Realizar consulta

All FAQs (1882 total: showing 881-900)

Is it possible to have a data logger initiate the data transfer, rather than LoggerNet?
What is the Network Planner?
What would cause a message from LoggerNet that the settings are locked by a user?
Using LoggerNet, what kind of file format checking occurs?
Does a user need to be permanently logged in to LoggerNet for the software to run and data to continue to be received?
Does LoggerNet stay connected to the data logger after the scheduled collection is finished?
How long does it take to install LoggerNet?
Can backups from older versions of LoggerNet work on newer versions?
How much memory does LoggerNet have?
Can a single copy of LoggerNet be purchased and installed on a laptop PC and a desktop office PC, or are two copies of LoggerNet needed?
Is LoggerNet included with the purchase of a data logger, or is the software sold separately?
Can a CS470 or CS471 be used to measure rainfall if the majority of the time there is no water to be measured?
Can the 4 to 20 mA analog output on the CS470 or the CS471 be used with a PLC instead of a Campbell Scientific datalogger?
Using a CS470 or CS471, how can bad measurements be prevented because of river silt or mud?
What should be done to prevent a CS470 or CS471 from being damaged by the current of a river?
Do the CS470 and the CS471 require a separate gas pump or gas bottle to drive the system?
What is the maximum length of tubing that can be used with a CS470 or CS471?
Is the only difference between the CS470 and the CS471 in their accuracy?
What is the best way to replace the sealant around the KH20 source/detector tubes?
Where is the KH20 listed as a component in the Short Cut (SCWin) program?

Anterior Siguiente