Toggle navigation
Productos
Soluciones
Soporte
Acerca de
Inicio
Productos
Soluciones
Soporte
Acerca de
Lista cotización
Contacto
Sitios web regionales
Sitios web regionales
Africa
Australia
Brasil
Canada
Centro Caribe
Deutschland
España
Europe
France
India
Japan
United States
ภาษาไทย
中国
Directorio paises
Log In
FAQs
Preguntas frecuentes acerca de nuestros productos y soluciones
Realizar consulta
Realizar consulta
Buscar
All FAQs
(1882 total: showing 1781-1800)
If an existing wind set is replaced with a wind monitor (05103-L, 05103-45-L, 05106-L, 05305-L), will more than the multiplier and offset have to be changed in the datalogger program?
We have an R.M. Young marine anemometer with a cable that is about 13 ft long. We would like to extend the cable another 20 ft or so. Do you sell a separate extension cable for the anemometer?
What is the power consumption (mA) of the 05103, 05305, and 05106 anemometers?
What is the procedure for orienting my wind sensor to the cardinal directions so that the wind direction readings are correct?
How can the 229-L be calibrated?
How are readings obtained from the 229-L?
Is calibration of the 229-L available?
If several 229-L probes begin returning very low positive and negative values for dT, what might be the cause?
How should the AM25T be used?
Can the AM25T be connected to an analog input channel on a device other than a data logger, such as a programmable logic controller (PLC)?
How can the datalogger build a text string and send it out the RS-232 port?
Instead of purchasing the entire 03001-L R. M. Young Wind Sentry Set, can I purchase just the Wind Sentry anemometer or Wind Sentry wind direction sensor to replace a bad unit from a previously purchased set?
I plan to set up an eddy covariance system in a remote wetland located in Michigan's upper peninsula. This site does not have power and is difficult to get to. I would like to set up a communication system that allows me to monitor the data from my office (Michigan Tech). There is a research station near the site (less than 5 km away--Seney National Wildlife Refuge) that could be used to collect the data before bouncing it to me.
I am writing from Universidad de Cuenca in Ecuador, and I would like to know if we can use ST-20 Argos Satellite Transmitter in Ecuador? Are there other choices for Ecuador?
Do Campbell systems support other satellite networks such as Iridium and Orbcomm? If the answer is "yes", do you know if the area of Somalia is covered by those services?
I need help with a satellite telemetry system to be used in northern Somalia for hydrological and meteorological station data transfer for a flood early-warning application.
What would be the best telemetry system for remote data collection from valley bottoms in a dense redwood forest?
Is the ST-21 Argos Satellite Transmitter compatible with the CR510 and CR10X?
I am looking for information on the 21X Micrologger, specifically about removal of the expansion memory module. I was trained on the CR10X, but have no info on the 21X.
Can a point-multipoint network be built using RF401 radios with a base and three remote terminals, a data logger at each terminal, a COM210 modem, and a remote PC with LoggerNet software?
Anterior
Siguiente