FAQs Preguntas frecuentes acerca de nuestros productos y soluciones

Realizar consulta Realizar consulta

All FAQs (1882 total: showing 1721-1740)

Can just the plastic, three-prong cup part of the anemometer be replaced on a weather station?
What is the conversion for evapotranspiration using wheat instead of turf grass? Also, is there anything for bare soil?
What is the 229-L heating element made of? In an acidic environment, such as copper mine tailings, would the sensor be expected to fail because of corrosion within five years?
I have an old CR-10 data logger that has not been used in years. The problem I am having is as soon as the power is shut off, all the data and programs are lost. Is there anyway to prevent this?
What is the optimum calibration frequency for a WindSonic?
Is it possible for a WindSonic to operate in extreme conditions like snow, glacial temperatures, and freezing rain?
Where is the interface cable for the WindSonic?
Do you have 1-d anemometer having 4 Hz or higher frequency to measure the vertical wind velocity?
Can vertical wind speed be measured by rotating the WindSonic 90 degrees?
Can the WindSonic produce an output of 4 Hz or higher frequency?
The WindSonic has the average 1 Hz output of 40 Hz block measurements. What does the 40 Hz block measurement mean?
Is it possible to connect a sonic anemometer and an electronic compass to a smart datalogger to give wind speed and direction on a non-fixed platform?
What is the reliability rating of the WindSonic?
Can the CR5000 store data with a rate of 1000 Hz?
If data is downloaded to a PC, the resultant “CR1000_Table1.dat” file is, for example, 150 kB in size. Is 150 kB necessarily its size on the CR1000? Is there any type of data compression being used?
Can the CR1000 or CR3000 communicate over TCP/IP?
Can the CR1000 provide alarms?
Can the CR1000 measure 4 to 20 mA signals?
Can I use the digital camera with my RF network and transmit the images back to the office using Loggernet?
I am trying to set up a CC640 with a CR10x (not the 2M variety) to send images via a freewave radio. I'm wondering if I need loggernet 3 (I have 2) or if I just need the lvcmd.exe file to view these pics through the logger?

Anterior Siguiente