Este producto ya no está disponible y ha sido reemplazado por: CR3000. Algunos accesorios, recambios o servicios pueden todavía estar disponibles.
| Services Available |
|---|
Resumen
The CR21 and CR21L were initially replaced with the 21X and 21XL. Although these loggers have been retired for many years, replacement parts remain available (see Ordering Info).
Note: The CR21 and CR21L were identical except that the CR21 was powered by alkaline batteries and the CR21L was powered by rechargeable batteries. Within this document, CR21 refers to both models except where specifically stated.
The CR21 featured an integrated design with built-in power supply, keyboard, and display. It looks very similar to, and is often confused with its replacement, the 21X Micrologger. The CR21 stored up to 608 data points in internal memory.
A typical field-based CR21 consisted of:
CR21 or CR21L Micrologger with
CR21 Instruction Set (PROMs)
Alkaline or Rechargeable Power Supply (in base)
Weatherproof Enclosure (new and old)
Imágenes
Preguntas frecuentes
Número de FAQs relacionadas con CR21: 1
-
A practical maximum is to connect one multiplexer per every two control terminals on the datalogger. Control terminals can be shared between multiplexers to increase the number of connected multiplexers. Sharing terminals, however, requires more complex wiring and programming. Users who would like to connect more than one multiplexer per every two control terminals are advised to contact a sales or support engineer at Campbell Scientific for assistance.
Especificaciones
- Seven single-ended analog inputs (-0.2 to +2.5 Vdc or
-2 mV to +25 mV, FSR) - Two pulse count channels (150 Hz (CH 8) and 50 Hz (CH 9), maximum input frequency)
- One 4 Vac excitation channel
- Three 2 Vdc sensor excitation channels
- Two binary inputs
- Four control outputs
- One 5 Vdc power terminal
- One 12 Vdc power terminal
- One a serial I/O port.