Imagen no disponible

Resumen

The CABLE2TP-L is a two-twisted pair, 22 AWG cable that has a Santoprene jacket. Insulation colors of the twisted pairs are red/black and green/white. An aluminum Mylar shield is grounded via a drain wire.

Leer más

Descripción detallada

The CABLE2TP-L is a two-twisted pair, 22 AWG cable that has a Santoprene jacket. Insulation colors of the twisted pairs are red/black and green/white. An aluminum Mylar shield is grounded via a drain wire.

Preguntas frecuentes

Número de FAQs relacionadas con CABLE2TP: 1

  1. If the cable attached to a sensor is too short, can more cable be spliced to the existing cable to make it longer?

    Whenever possible, purchase a sensor with the desired cable length. Some sensors have a user-specified cable length, whereas other sensors have a set cable length.

    Sometimes, an old cable can be replaced with a new, longer cable.

    Generally, additional cable cannot be spliced onto the existing cable because:  

    • Some sensor cables have bridge completion resistors at the pigtail end
    • Some sensors are calibrated based on cable length
    • Sometimes the color in the insulation is not the same as that visible at the pigtail end
    • It is possible to introduce errors or malfunctions depending on the integrity of the splice

    Splicing cable together increases the likelihood that water may enter the cable and cause shorting, corrosion, and some other potential issues, which in turn can cause measurement issues.

    Because of the potential issues, do not splice any sensor cable without first contacting Campbell Scientific to discuss the sensor in detail.

Visite la librería de FAQ